Use a wrench on the belt tensioner. If there is a square hole, use the socket handle only, if not, use a socket the size of the bolt in the center of the tensioner pulley. Use only enough torque on the tensioner to release tension and slip the belt off of one of the pulleys. (You don't want to loosen the bolt, you only want to move the tensioner.) You did not ask this, but it is important. Pay attention to the routing of the belt. When reinstalling, make sure the grooves are centered and seated on all the pulleys BEFORE slipping the belt over the last pulley. (Of course, using the wrench to move the tensioner.) This can be tricky. You only get one chance, because if you crank the engine with the belt not correctly seated, you will be buying a new belt, and you could get hurt.
There is a special tool I saw in a pawn shop that is just for that.
1995 Buick LeSabre how do i reset my radio
There is no tension adjustment. Tension is automatically adjusted by the idler pulley.
Piece of Cake!! remove serpentine belt (search here for answer how to), remove the lower of 2 bolts from the alternator, loosen the upper, rotate the alternator up, remove the bolt. Install is the reverse.
where is the engine controle module located in a 1995 buick lesabre
A 1995 Buick LeSabre takes 7.4 quarts of transmission fluid. Dextron lll transmission fluid is recommended for use in the Buick LeSabre.
I had a 1995 buick lesabre and the A/C compressor went out in the winter time. I waited until spring to replace the compressor. In the mean time, I used a Dayco 72.10 inch belt and bypassed the A/C compressor and it runs fine.
To replace the fuel pump on your 1995 Buick LeSabre, you must remove the fuel tank because that is where the pump is located.
location of heater damper on 1995 buick lesabre
With a jack or a hoist.
Connect the wiring harness to the back of your 1995 Buick LeSabre stereo. Secure the stereo with the stereo retaining screws.
Yes, you have to loosen engine mount