where is locate the main relay on 1996 acura integra
The factory tape deck on a 1996 Acura Integra can be taken off by removing the center console. Once the console is off remove the remaining mounting screws on the radio and pull it out.
Type your answer here... Where is the location of diagnosis connector OBD 2 for 1996 acura integra?
The 1996 Acura Integra OBD 2 port is under passenger dash
not likely if your talking about 1991 as being the DA integra and the 1996 as being the DC2
about 90,000 miles
if it looks exactly alike and bolts on exactly the sameway, it will work.
If yoor 1996 Integra has the1.8L engine, the thermostat is located at the back of the motor at the end of the bottom radiator hose.
You will need to remove the covers from your 1996 Integra rear speakers. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers.
its probablly r-134-a freon
There is 2 o2 sensors on 96 integra. 1 is after the headder and the 2nd one is at the end of the cat
Approximately 4.5 quarts on a 1996 Integra GS-R (So it should be close for the '95). Approximately 4.5 quarts on a 1996 Integra GS-R (So it should be close for the '95).
1-3-4-2 Rotor turns clockwise.
how to remove gas tank from acura tl 1996
nothing, do it by yourself
No it is not all ls motors are very reliable
just follow the lower radiator hose to the engine and that is where it is sitting@
replace the distibuter
On the passenger side of the center console behind the head unit for the stereo.
go to your local auto parts store and buy some NevrDull or GlassX.
Oh yes that would easily fit right in, mostly any Honda motor will fit in .
simple left of the engine. there should be a mount holding it into place on the left of the motor, if u look a the mount under it is the transmission