answersLogoWhite

0

What else can I help you with?

Related Questions

What is spark plug torque Acura Integra 1998?

From the Haynes Acura Integra Repair Manual, 156 in-lbs.


What is Spark plug gap for 1986 Acura Integra?

0.041 (in)


Spark plug gap for a 1994 acura integra LS?

.044


What is the spark plug torque for an 1996 acura 2.5 tl?

According to the AutoZone website : For a 1996 Acura TL , 2.5L 5 cylinder engine : The spark plug torque is ( 13 Ft/Lb )


Where is a distributor located in a 1995 Acura Integra?

1995 Acura Integra probably doesn't have a distributor, it would have coil packs, follow your spark plug wires from the spark plugs back. where the spark plug wires stop that's what has taken the place of your distributor. Its computer controlled the computer is probably under the dash on the passenger side of the car


What is the order to plug the spark plug wires into the distributor cap on a 1991 acura integra?

1 3 4 2 clockwise from bottom left


How do you replace an Acura Integra distributor?

Unplug all the spark plug wires. then loosen the screws holding the distributor on, remove it, put the new one on and screw it in, then replace the spark plug wires


Where is the OBD plug located on an Acura Integra 2000?

The 2000 Acura Integra OBD 2 port is under passenger dash


Were do you connect the plug for the check engine light in a acura integra 1996?

On the passenger side of the center console behind the head unit for the stereo.


What is 2001 acura integra spark plug gap?

The spark plug gap for a 2001 Acura Integra typically falls between 0.040 to 0.044 inches (1.0 to 1.1 mm). It's important to check the owner's manual or verify with the manufacturer for the exact specifications, as they can vary based on the engine type and any modifications. Proper gap settings ensure optimal engine performance and fuel efficiency.


Where is the diagnostic plug for 1996 Acura Integra?

The diagnostic plug for a 1996 Acura Integra is located under the driver's side dashboard, near the steering column. It is typically found above the accelerator pedal, and you may need to remove a cover or panel to access it. This OBD-I connector is used for connecting a diagnostic scanner to retrieve trouble codes from the vehicle's onboard computer system.


Why would a 1991 Acura Integra not start?

may be many things , spark plugs, spark plug cables , distrubuor , gas , alternator not charging the battery or a bad battery maybe evn gas - *PhAZe II* -