0
Replaced the spark plug and cleaned the filter and still it will not run.?
Sawblade
need help figuring out what else to try to fix my leaf blower! i have replaced the spark plug and cleaned the filter, but it still won't start, like it is not getting fire to the plug!
also, i put fuel directly into carburetor. any help would be appreciated.
thanks, ed
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
I have replaced the fuel pump filter regulator fuel block seal spark plugs and still wont run what else may be the problem?
Is it getting spark?
Why wont your 3.5 Briggs stratten engine start It has new spark plug carburetor cleaned good spark but still will not go?
carb. adjustment, fuel filter or the engine is shot.
Briggs 4.5 lawn mower has lost horsepower opened it up cleaned all part with carb cleaner cleaned the air filter put new gas and still low power?
Change spark plug
What does it mean when none of the toilets work but the water is still running in the sinks?
The filter or jet inside the toilet inlet has become blocked and needs to be either cleaned out or replaced.
2001 alero I replaced the fuel pump and it still won't start any ideas?
Does the new pump run? if yes then is there spark at the plugs? also did you replace the fuel filter?
I have replaced the fuel filter in my 2003 ford expedition and it still doesn't start up immediately any suggestions?
Check the starter, spark plugs, distributer cap, battery.
We replaced every sensor on your 1994 s10 and the truck still has a bad miss in it?
Bad spark plug wires or spark plugs can cause your 1994 Chevrolet S 10 two misfire. A plugged fuel filter can also cause the vehicle to misfire.
Replaced spark plug and spark plug wires on Honda civic 1999 but still misfiring?
check the gappings of your spark plugs, it must be uniform.
I have cleaned my filter but i still have no suction in my skimmers?
I just had change my sand filter and it seem working fine, but it doesn't have enough suction at the skimmers, why it does this?
I have 98 Firebird 3800 V6 and have replaced the plugs and wires as well as the coil packs fuel filter cleaned the injectors but it still lacks power runs ruff. What am I missing?
Do a compression test Check for plugged catalytic converter
1997 ford mustang v6 recently replaced fuel filter and cleaned throttle body but it still stalls while driving has a hard time idling on start up and dies out sometimes?
Maybe need tune up
Your 98 Ford Crown Vic Stutters when in idle of low acceleration you have replaced the fuel filter Air Filter and spark plugs but the problem is still occurring The engine light is also on Any ideas?
Yes, have the code read to find the problem. There are a number of sensors that will cause this.
