Yes. Always a good thing to do and imperative if track-rod ends are changed. Alignment alters over time; things bed in, wheels get kerbed, potholes get struck, emergency stops occur. And then you fit brand new, tight ball-joints..........
how do you replace ball joints on a 2000 envoy
Replacing Ball joints Check Related Links Below
no.not usually.
Rather than replacing just the ball joints, replace the whole arm as replacing just the ball will more than likely not work. Use ball joint remover tools to remove and replace.
The 2004 Chevy Malibu ball joints will cost approximately $45 each. Replacing the ball joints will require approximately 3 hours of labor.
There are no upper ball joints - that role is played by the McPherson struts. See "Related Questions" below for more
Cost on replacing ball joints on a 2001 Buick lesabre
Most of these now require changing the entire arm when replacing the upper ball joints. Any national parts chain will carry them.
never use used frt. end parts. its one thing for a used starter to fail and your car wont start but to be driving 60 mph and have a ball joint come apart is another If you know what to look for and not install worn out parts you will be fine, after all, every vehicle on the road has used ball joints. yes you are right. but the only way to check the wear properly is to install. what is the cost of new ball joints compared to used then the time it takes to install... again, put new frt. end parts on.. a ball joint costs 30.00. a used one is what? 20.00? If you are replacing damaged suspension parts because of an accident, you can purchase complete good used a-frames and spindles with ball joints from a respected used auto parts dealer, if you are short on cash. yes, in an accident where you have to buy the control arm, ball joint, spindal, rotor,caliper ect. as an assembly then yes. but the question was only replacing ball joints and again just replacing ball joints is not worth buying used stuff. spend $10.00 more and do it right.
With labor included, the average price of replacing a ball joint is $400. If the individual has chosen to do the work themselves, the price of a ball joint is $60 to $80 a piece.
Top ball joint is 60 ft.lbs., initial. Then tighten to align hole for cotter pin. Bottom ball joint is 94 ft.lbs., initial. Then tighten to align hole for cotter pin
Have the car checked at a wheel alignment shop.