0
turn on the ignition till you see all the warning lights. depress the gas pedal 3 times with in 10 seconds. turn the key off it is rest. remember not to start the vehicle during this procedure.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you reset check engine light on Jeep Liberty diesel?
How do you reset engine light on jeep liberty diesel
How do you reset a check engine light Jeep liberty?
You reset it with an OBD2 scan tool after it is repaired.
Can you reset the oil light in a Jeep Liberty?
The oil light in a Jeep Liberty can be reset. To reset the light turn the ignition switch on or off without starting the engine. Next depress the acceleration pedal at least three times and then switch the ignition switch in a locked position.
How do you reset engine light after repair on a Jeep Liberty?
disconnect your battery for 45 secs and reconnect
How do you reset the check engine light on a 2002 Jeep Liberty?
You can unhook the battery or use a scan tool.
How do you reset the fuel inertia switch on a jeep liberty?
Jeep does not use inertia/reset switches.
Where is the reset for the fuel pump on a 2008 Jeep Liberty?
Jeep does not use inertia/reset switches.
How do you reset the abs light on a 2010 Jeep Grand Cherokee?
The abs light is reset with a scan tool after repairing the failure that caused the code.
How do you turn off the perform service light if you just had a oil change in your Jeep Liberty?
Take it to the dealer and get it reset.
How do you reset the fuel pump inertia switch on a Jeep Liberty?
Jeep does not use inertia/reset switches.
How do you turn off the engine light in a 2005 Jeep liberty?
The check engine light is reset with a scan tool after repairing the failure that caused the code.
How do reset air bag light on a 2010 jeep wrangler?
The airbag light stays on when the computer has detected a malfunction and set a code. The light can not be reset until the failure is repaired.
