Stage 1. 20Nm Stage 2. + 180 degrees Stage 3. + 180 degrees.
THis ain't no question
It should tell you in your Repair Manual. Don't have one go [http://www.themotorbookstore.com/land-rover-range-rover-manuals.html Here]
Land Rover Discovery Series 1
Stage 1. 20Nm Stage 2. +180 degrees Stage 3. + 180 degrees.
I believe it is 5x120
The head bolt torque settings for a Rover 216 typically require an initial torque of around 20 Nm (15 lb-ft), followed by a further torque of 90 degrees. It's essential to follow the specific sequence for tightening the bolts to ensure even pressure across the cylinder head. Always refer to the vehicle's service manual for the most accurate and detailed specifications.
Another 96 Range Rover.
The torque setting for the crankshaft pulley bolt on a Rover 75 diesel is typically around 180 Nm (Newton-meters). It's essential to ensure that the bolt is properly torqued to avoid any issues with the pulley alignment or engine performance. Always refer to the vehicle's service manual for the most accurate specifications and any specific procedures related to this task.
5x120 mm
420i.
Fn T
5x120mm with a 58 offset