Fn T
420i.
Fn T
crankshaft pulley
TD5 Engine rocker torque setting is 10Nm or 7lbft
11 nm then 2 x 180 degree turns
Crankshaft is inside the lower part of the motor.
On the Rover 75 V6 engine, the crankshaft position sensor is typically fitted near the crankshaft pulley at the front of the engine. It is positioned to detect the position and rotational speed of the crankshaft, which is crucial for engine management. Accessing the sensor may require removing components such as the engine cover or other surrounding parts. Always refer to the vehicle's service manual for precise location and replacement instructions.
the crankshaft sensor lokited ner the flaywil bihind the transmisin
The crankshaft position sensor on a Rover 416 is typically located near the bottom of the engine, often on the engine block or near the crankshaft pulley. It may be positioned on the transmission bell housing or at the rear of the engine, depending on the specific engine variant. To access it, you may need to remove components such as the engine cover or other obstructing parts. Always consult the vehicle’s service manual for precise location and removal instructions.
1. tighten to 20nm. 2. then tighten all an extra 360 degrees.
Engine code K16-1.6 Head torque Stage 1. 20Nm Stage 2. + 180 degrees Stage 3. + 180 degrees.
Lower left side of crankshaft-looking at engine from front.