11 nm then 2 x 180 degree turns
According to my Haynes manual, 20Nm. Tighten to this force on the first cycle of bolts (in the correct order) and then half a turn on the next cycle, and then another half a turn on the last cycle.
The cylinder head torque settings for a Land Rover 300 DTI starts at 40Nm for all bolts. Then for M10 x 117 mm long 60 degrees, M12 x 100 mm long 60 degrees.
1. tighten to 20nm. 2. then tighten all an extra 360 degrees.
TD5 Engine rocker torque setting is 10Nm or 7lbft
manual de torque
420i.
Fn T
Engine code K16-1.6 Head torque Stage 1. 20Nm Stage 2. + 180 degrees Stage 3. + 180 degrees.
THis ain't no question
Fn T
40NM initially on all head bolts Then... 60 degrees on all Then another 60 degrees on all Then the M12x140mm bolts are a further 20 degrees
initially you tighten all bost to 28 newton metres then you angle tighten by 90 degrees leave for 5 mins and angle tighten by another 90 degrees this information was supplied to me by a trained rover mechanic i did it on my metro 1.1 on a j reg and it was fine