unplug the wire that is connected to the coil. {not the spark plug wire} the small wire that goes to it. and see if it starts up. if so you will then have to pull the spark plug wire to shut the mower off. make sure that you pull it with a rubber glove on so you don't get shocked or you can pull it with a pair of pliers that are insulated. if that works. shut off key. plug the small wire back up and then look at the wires going to your starter where they "plug" together. unplug and turn it around, then plug it back together. that should work. if you have unpluged any of the wiring and plug it back together, you may have plug it in backwards. I DID {lol} hope that helps Take care
snapper the engine was made in georgia
313717
It is a Briggs & Stratton Engine, so get the engine model and try jackssmallengines.com.
The coil is under the cowling on top of the motor where the flywheel is.
Oil change indicator will come on at 49 hrs for two hrs of operation than will reset itself.
How do I change points to electronic ignition on a 5 hp briggs & stratton small engine?
if it has a Briggs engine go to briggsandstratton.com [all one word]
Yes, most all of the Briggs single cylinder engines are exchangable. You just need to be concerned to make sure that you don't under power your mower. In your case that is not a problem.
Husqvarna makes it. Briggs&Stratten Platinum engine. General Transmission Element V transmission.
If it is a Briggs engine you will see the plug at the base of the oil filler tube pointing to the right side of the tractor. If it is a Kohler engine the plug is on the left side just in front of the oil filter.
Depending on the model it may not have one. If its a Briggs engine and you don't see it then it probably doesnt have one.
you can goto briggsandstratton.com and get a manual for that engine,