If it has a diesel motor, it can be done safely. If it uses petrol/unleaded gasoline or LPG, then absolutely not. Static electricity can cause an explosion.
No. Lower the load to the floor, set the parking brake, turn off the engine.
what should be used to assist the forklift operator with dropping off and picking up material
A fully charged battery should read approx. 12.8 V without engine running With engine running should read Approx. 13.8-14.2 Volts
Never!!!
With key on engine not running pressure should be 9 to 13 psi Engine at idle pressure should decrease by 3 to 10 psi on a throttle body. On a multi port injection key on engine not running pressure should be 41 to 47 psi. Engine running at idle pressure should decrease 3 to 10 psi. Central multiport fuel injection key on not running should be 58 to 64 psi. Engine running at idle pressure should decrease 3 to 10 psi. Central sequential electronic fuel injection key on not running pressure should be 55 to 61 psi. Engine running at idle pressure should decrease 3 to 10 psi.
If the engine is not running the pressure should be 35 to 40 psi. If the engine is running the pressure should be 30 to 45 psi.
Engine running at idle you should read 13.5 to 15.5 volts.
It depends on the model and serial # of your forklift. A YAM forklift is like asking for the specs on a Ford. Need all the info you can find on the lift and the engine.
== == It is a 12 volt system. The alternator should put out 13.5 to 14.5 volts with the engine running.== == It is a 12 volt system. The alternator should put out 13.5 to 14.5 volts with the engine running.
1496 ccm
one bolt at a time
it is generally part of the alternator.