No, they are held in with will power.
Say to to your self "my headlamps will not fall out" 3 times a day before meals, and you will be fine...
:)
On the other hand they might be screwed on.
open the hood behind the headlights there should be two white retaining clips holding the headlight in place. remove the clips and carefully pull the headlight remove the black rubber cover twist the socket and pull out the socket with the lightbulb pull out the bad bulb. before installing the new bulb DO NOT PUT YOUR FINGERS ON THE NEW BULB DUE TO THE OIL ON YOUR FINGERS WILL CAUSE THE NEW BULB THE BURN OUT JUST AS QUICK!!!!!!! then reverse the procedure.
There should be 4 to 5 spring clips holding the top of the air box on. Pop these clips and the box should split in the middle. The filter is inside.
Use Snap Ring Pliers on the clips (3) - squeeze pliers closed and while clip is spread open pull up with needle nose pliers
Push lower end of rear seat back to unlock clips (takes a bit of effort) Lift bench out Should be clips or bolts holding the top of the rear seat - release these Push up on the upper section of seat to release top clips Push lower end of rear seat back to unlock clips (takes a bit of effort) Lift bench out Should be clips or bolts holding the top of the rear seat - release these Push up on the upper section of seat to release top clips
There are two clips on the wall that holds the headlights. Push the clips away and pull the headlight housing out.
There are two clips on the back side of each headlight that you lift vertically. Once the clips are removed the headlights come right out.
Yes there is.
The air box is located on the right/middle of the engine in a black box. There should be i believe four clips holding the top on. Pop those clips and remove the top, the filter is sitting right there.
Look inside the wheelhouse you'll see plastic rivits holding the flare. Cut the heads off them. The rivits are a one time use. Then reach you hand into then bumper. There should be 3 clips going from flare into the cover. Squeeze them to release them from cover. Now you should only have the plastic clips holding the flare to the metal 1/4 panal. I would just pull hard to remove it, and replace the clips. But you can try to use a small pick to release the clips from their sides, if you need to try to save the clips. But even the pros still break a few...
Each headlight should have two (or three?) plastic clips that look somewhat like a six inch ruler holding it in. Pull the clips upward to release, then slide the headlamp assy. forward.
on the back seat there is two clips. if u pull up on the seat you will see the two clips. pull out on the clips and the bacl seat should come right up and there there is two bolts holding up the back rest. take out the two bolts and then lift up.
there should be 2 screws on each side and just un-screw then and pull it off, or it may have 2 spring clips holding it in place.