0
It all depends on the bearings that you need to replace! Get some quotes! If it is bearings inside the engine, then the mechanic you go to is going to have pull the engine anyways, so if there are no other problem with your engine but some bearings then i would just have the bearing replaced, but if you have other problems due to the bearings going out, then i would replace the engine. Hope i helped
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Should I replace Mazda engine or buy new car?
Replace the Mazda engine.
How do you replace the rear wheel bearings on a 2004 Kia Sedona minivan?
I recently did this for my 2004. I found it was cheaper to replace the entire wheel hub then to buy the bearings. The bonus is the new wheel hub comes with the bearings already to go.
How do you replace front wheel bearings 1995 mark viii?
You have to buy the wheel bearing assembly.
What do I need to buy to replace the front wheel bearings on my 97 Geo Tracker front assembly or just the bearings?
you need to buy bearings and bearing races most times they will come as a set you will also need axle seals and you will need bearing grease
How do you replace front wheel bearing on a 1995 Prizm repacking them with grease?
Wheel bearings on 1995 Geo Prizms are sealed units and cannot be repacked with grease. You must buy new bearings to be pressed on hubs by mechanic with proper tools. If bearings are worn, replace ASAP before bearings start damaging hubs, you'll save bunches of money.
How do you replace the wheel bearings in a 2005 2wd Chevy 1500 pickup truck?
you don't. buy a new wheel hub
Your 95 aerostar has blown head gasket and possible a cracked engine should you replace the parts or engine?
replace the motor. you can buy a new one or find a junkyard/salvage yard and get a used one, and some even install them
How many spark plugs do you need to buy for your 1999 Isuzu trooper to replace them?
if engine has 4 plugs buy 4 if engine has 6 plugs buy six
How do you replace ball bearings of a ceiling fan?
Yes, I have done it. It took about 15mins once it was removed from the ceiling, the fan I fixed required only 2 inexpensive bearings (6202 or 6203 I think).
Where can you buy fingerboard bearings?
www.zshred.com they have really good bearings and a lot more
Should you rebuild your engine or buy a new engine?
balls?
How do you change pistons on a Mitsubishi gto 3000?
Call a mechanic. This is not an "at home" type of repair. To replace pistons, you must tear the entire engine down, and replace all gaskets and bearings. I assume you are thinking of lower compression pistons for a turbo build up. Don't bother. Buy a complete engine with the turbo and duct work from a wreck, if available. You could spend more trying to rebuild yours.
