Want this question answered?
Black holes are an interesting phenomenon that astrophysicists would like to explore, but naturally, they would not want to get too close.
The meter should be on the AC scale. In Canada and US the reading should be 240 on the outside blade holes and 120 volt from the outside blade holes to the center blade hole. The U shaped pin is the ground. No voltage from it to the center pin.
more holes
Because the kids at the camp have to dig holes to find the buried treasure.
Black holes are round because they are formed from dead stars and white holes. As you can guess a star is a sphere and that is why black holes are round.
you should probably avoid them . . .
The only large hole should be the one you need to run the wires and cables through. Other than there there should be no large holes.
No, you should never have to trim a head gasket. If the holes do not match up, you have the wrong gasket.No, you should never have to trim a head gasket. If the holes do not match up, you have the wrong gasket.
5 to 2 should do it!
The holes for a pig cooker should be about a half inch to an inch wide. These holes must be drilled into a pipe for the cooker.
The best way to fix holes in a mesh pool cover is to sew it. If the holes are too large for this you should consider just replacing it.
They should be above grade, below grade or filled with mortar.
Black holes are an interesting phenomenon that astrophysicists would like to explore, but naturally, they would not want to get too close.
The holes are actually stitched closed. So there aren't actually any holes. Don't go poking around where the teeth were, you might cause an infection.
A tank with holes big enough for it to escape..
Does it have holes punched in it? That would mean it was voided.
Since carbon can bond with up to four other elements at once, the model of carbon should have four holes.