That should be fine. The device that you use to connect the two wires should be approved for AL- Cu connections. If you are using a wire-nut then check that it is approved as there are some that are not. If it is a direct connect to the device via terminal screws then check the spec. sheet that came with the smoke alarm.
Try turning your key in drivers door to unlock, should reset the alarm
of coures it will connect with a wire
How do you attach a siren to an electronic clock alarm
digital alarm clocks have copper but analog clocks depend on who made it
Pull out the Fuse for alarm system.
Takes pro tools not for diy mechanics. I hate mine as well, ALL YOU HAVE TO DO IS CONNECT THE HOT WIRES THAT GO TO THE STARTER AND IGNITION DIRECT, AND PULL OUT THE FUSES TO THE ALARM THAT SHOULD CANCELL THE ALARM..I HAD THE SAME PROBLEM..
Get a pressure plate in Minecraft and a howler alarm once that, get the main essentials of redstone. Now your ready, put pressure plate down the connect the wiring with redstone and place the howler alarm inside the house then connect the circuit to it. have fun with the alarm!
In an alarm condition, the siren output is a steady output, rather than a pulsed one. To connect the car alarm system to the car horn, simply hook it up with the relay to switch the horn power.
Whatever burglar system you choose, make sure it is connect to your phone line so it can notify authorities when there is a problem. Even the most basic alarm system should have this feature.
1 hr service call +cost of material
Both conductors are copper. One is just electroplated so it looks silver. This is so you can know which conductor is which when you hook them up. The copper-colored conductor is traditionally used as the positive, or plus wire. The silver-colored wire is used for the negative or minus wire. Some cables use a foil shield. The shield is mylar (polyester) coated with aluminum. The shield is not really one of the conductors, it is only used to drain away interfering signals before they reach the inner conductors, so it need not be a super good conductor. Aluminum is used for the foil shield partly because it is lightweight, but mostly because it's much cheaper than copper.
you can but, you need to open the siren of your alarm system and disconnect the chip inside. then reconnect that to a voice amp or your stereo, simple as that.