nothing to be gained from removing it unless you know of some present contamination.
Years ago there was Formaldehyde on Particle board, but its gone now & in an old floor it would have disipated long ago..
If you fear it just seal the floor by rolling a coat of Deft or some paint
If it is a deep scratch you cannot usually remove it. Sometimes if a scratch is somewhat on the surface then a floor stripper might remove its appearance.
MDF uses a finer particle than particleboard. The result is a board that machines better ( more evenly) and has a nicer finish surface whereas particle board is used more in underlayment situations where the board will be hidden.
to have sex
Wires.
Heating vents should be placed near or on the floor in a room because heat travels up not down.
Yes it is.
With great difficulty and not much use. Below the laminate there's particleboard, which is pretty much useless as a table surface.
Remove the floor
It's "code" for Particleboard.
Yes Get a "power planer"
The price would depend on the amount of work, grade of particleboard, any preparation or finishing work required, and the difficulty of accessing the work area. The material costs will be about $19 for a sheet (3/4" x 4' x 8'). The costs to put in underlayment for a floor will be a whole lot different than (for example) installing it in an attic ceiling. A word to the wise: Never ever ever install particleboard where it may become wet, or will be continuously exposed to high humidity.
You should immediately try to mop up, or remove as much, if not all, of the water as you can. Leaving the water on the wood floor will cause it to warp out of shape.
Defeat all the creatures on that floor (Floor 255) and it should disappear.
cost to remove tile floor
With a replacement floor.
look around the bottom of the seat their should be bolts leading through the floor board take those out (their should be 4 of them) and just remove the seat.
There should be retaining bolts at the feet of the seat keeping it down to the floor of the vehicle. Remove the nuts and you should be able to lift it ot.