no.
needs an o ring in the hose
Outdoor fountains are typically hooked up to water mains and don't need to be plugged into a hose.
Could be as easy as tightening the hose clamp. However if the hose being cut by over-tightening the clamp caused the leak, you may be able to loosen the clamp, slide the clamp to a good section of hose, and retighten. Be sure that the fitting is not collapsing. If it is, replace it, remembering to use Teflon sealing tape on the fitting threads. If the hose is too badly damaged it may need replacement.
White shoes and brown hose.
A cam lock is a crimping device method of connection either hose to hose or hose to pump. You place the band into the hook, pull the lever and it crimps the hose - it is a cam lock connection.
how to repair 1999 Toyota Camry radiator hose upper connection pipe
Connection of the washer drain hose to the tub drain is very important. This will help prevent leaks for example.
follow the top radiator hose back to the engine, it should be right under the hose connection follow the top radiator hose back to the engine, it should be right under the hose connection on the 3100 V6, It is buried literally under the throttle body, behind the heater pipe (pipe from the water pump area, across and then back toward the firewall. 2 small nipples carry hot water to TB.)
I replaced the fuel pump i n my beretta and the original pump doesnt have this hose connection. The original has a brake booster looking conector between the pump and the fuel line. Your new pump should have come with the new hose and clamps.
there is a connection on canister its the only connection the refill hose will fit
The two common causes for a toilet tank hose leak are the threads and the hose itself. Turn the water off, unscrew the hose, and wrap the threads with Teflon tape available at any hardware store. Reconnect the hose and turn the water back on. It it still leaks, consider replacing the hose as it may have a hole in it.
The male fitting of a fire hose, when rolled, should be on the inside (in the center) of the rolled hose.Also, varying by the station or district protocols, if the female fitting is on the inside, it means that the hose is out of service or damaged.