The male fitting of a fire hose, when rolled, should be on the inside (in the center) of the rolled hose.
Also, varying by the station or district protocols, if the female fitting is on the inside, it means that the hose is out of service or damaged.
The male fitting of a fire hose should be located on the exterior of the rolled-up hose for easy access and connection when needed. It is typically positioned on the outermost layer or at the end of the rolled hose to ensure quick deployment and reduce the risk of tangling or kinking when unraveling the hose during an emergency.
I believe it has a rolled tension pin going through the fitting. Using a hammer and drift pin push the rolled pin out and the line should slide out. Becareful as there is a small o-ring inside that will probably fall out.
It should be rolled in the direction as shown in the manual.
Should be right behind the drivers seat in the storage compartment.
The Budget Mini Storage store is located in California in San Mateo. It serves the Peninsula area and if one wishes to find the exact address, they should visit their Yelp page.
the fuel filter should be located just below to the right of the air filter box. this is in the right side of the engine compartment. to change the fuel filter you must remove the air filter box. the top fitting is a banjo fitting and the bottom fitting is a standard screw in flared fitting.
Should be located in the fuel inlet line of the carb.Remove fuel line and fitting at carb.
no
primary flow
Cold feed
The low pressure side of most cars is the larger of the 2 lines. This should hold true for the Comanche as well.
Yes
Cold feed