OK, most cars its really easy, just a few steps you have to go through. FIRST, if you are replacing a window odds are the old one is broken, so take off your door panel (usually a screw on the door handle surround, its kinda hard to see sometimes), and the if you have roll up windows take a rag and point the window handle down, and stick the rag under the handle base and wiggle it in a U pattern and it will snag the little clip holding the hanlde. SECOND, Once you have you the door panel off peel back the plastic(its a plastic sheet, keeps the water out) once you get it out take a vacuum and get out all the broken glass out of it, and take a flathead screw driver and get the glass chunks out of the window channels. THIRD, once you have all the old glass out, roll down the window and look for a bar that goes horizontal(it typically has 2 bolts on it and will have the rest of the glass attached to it) and take that off and trash it(keep the bolts). FOURTH, grab the new window and put it into the channel with the smaller end down(front) and kinda work it into place. once into place guide it down and line up that horizontal bar, and bolt it in place. FIFTH, test it out and if all is good put it all back together. DONE!!!!
Remove the inside door panel. Remove the window retaining clips. The window will slide out. Reverse the process to install the new window.
You can find the window relay switch inside of the drivers side door. You will need to remove the drivers side door panel in order to access the window relay switch.
Many vehicles with power windows have a switch on the drivers side window control panel that can lock out control from all other switches, check to be sure that switch isn't on.
I need to know the best way to remove and install the new window motor for a 96 Ford Windstar drivers side. Ray
remove master switch from door. remove wire harness from back of switch. with a jumper wire brige wires until window raises. then buy new master switch and replace
Tell me if just one window or all of them quit working
audi a3 how much replace drivers side window
150
Need instructions on how to replace a manual window regulator on drivers side on 1995 saturn
how to replace1994 grand drivers side power window motor
for what car? 2000 gm s15
Electric or manual?
Replace the window regulator.
replace the power window motor inside the door. You will have to drill out the rivets and replace with nuts and bolts
cANNOT GET THE DRIVERS SIDE WINDOW UP, IT IS PARTWAY DOWN AND HAVE TRIED SPRAYING CLEANER IN IT, NO GO. WHAT DO I DO? The switch, or relay, for that window is faulty, or worn out (since drivers window is most used). Replace it.
First... get a repair manual. Follow the instructions...
How do you remove and replace the motor for the drivers side power window in a 2000 Sienna
The window is not off track. The window regulator is broken. In most cases you will have to replace the window motor and regulator as an assembly.