Your motor is not getting fuel. Check that the shut off valve is on .Change fuel filter if that dose not solve problem get cab cleaned
30 Seconds
A starter solenoid can be bypassed by connecting a jumper wire between the battery and ignition posts on the starter. This will cause it to spin immediately without using the ignition switch.
Sometimes; if you operated the vehicle for some time with low voltage it could destroy your starter. Low voltage is the worst enemy of a starter motor.
When and if the engine stops at the point where the starter gear is aligned with the missing teeth the starter will just spin and not start the engine. Over time even if the starter turns the engine over it will eventually ruin the starter. You need to replace the flywheel and the starter immediately.
Weak battery? Loose battery or starter cable? Bad starter? Timing too far advanced?
No, you do not get to choose a Starter Pokémon in "Pokémon HeartGold" immediately after arriving in the Kanto region however later on after you've defeated all of the 8 Kanto Gym Leaders including Blue, you'll get to choose a Kanto Starter and a Hoenn Starter.
You must Have Torchick as a Starter then you will get it immediately
The clicking noise you can hear is the starter solenoid clicking into place. If the starter motor does not turn the engine immediately, it is probably the best place to look. it sounds like the starter motor is faulty.
Low battery voltage? Perhaps a lose or corroded battery cable Loose starter cable Weak starter solenoid Weak starter
If this happened immediately after replacing the starter, I would say the wires on the solonoid are connected wrong. It could be the switch but I think it is the wiring.
a grinding sound usually means a broken teeth on either the flywheel or the starter pignion gear. your starter can also be loose.
In manual star delta starter, the change over from star to delta does not happen automatically. The operator or user puts on the starter, and after few seconds he pushes a lever or handle to change over to Delta. In automatic method, change over happens from star to delta using an automatic preset timer.