The speedometer cable on a 1986 Chevy Celebrity is between the speedometer and the transaxle. To remove the cable from the speedometer according to the factory service manual:
1. Remove the trim panel below the steering column. Take note of what you take off, you will need to replace it.
2. The cable is held to the speedometer with a quick disconnect. Reach up under the dash and push the release to disconnect the cable. The release is near the top of the cable. I would put a wire or string around the cable to guide the new cable in place.
To remove the cable under the hood:
1. Pull the speedometer cable out thru the firewall. If you put a wire or string on it to guide the new cable in, take it off the old cable.
2. Take careful note of the routing of the old cable, follow the cable down to the transaxle and unscrew the fitting at the transaxle and take the cable out.
You should now be ready to install a new cable. Put the cable in place in the transaxle and tighten the nut. Route the cable as the original was, then if you put a wire or string in place attach it to the new cable and start it in the hole thru the firewall.
Inside the car:
If you used the wire or string pull on it to draw the cable inside the car, guide the cable into place on the speedometer housing and engage the latch. Remove the wire if you used it.
Put the trim panel under the steering column back in place.
Cable is mechanical.
The back of the speedometer and the tailshaft of the transmission.
The firing order on a 1986 Chevrolet Celebrity V6 is: 1-2-3-4-5-6.
To replace the speedometer cable on a 1986 Chevy Celebrity: According to my factory service manual: 1. Remove the trim panel underneath the steering column. 2. The cable is held in place by a quick release button. Reach up by the steering column and push the quick release button and pull the cable off. I like to attach a wire or string to the cable so that I have something to pull the new cable in with. Then under the hood: 1. Pull the speedometer cable out of the dash, if you used a wire untie it. 2. Follow the cable to the other end at the transaxle. Unscrew the nut that holds the cable to the transaxle, pull the cable out. Reverse these steps to install the new cable. Be careful to follow the route of the original cable.
There is no speedometer cable anymore, it's all electronic.
Probably cable
what type of engine do you have?? V6
On the 2.8L V6 the distributor cap is held on with two screws. Unscrew the two screws and pull straight up on the distributor cap to remove it from the distributor.
I found one source that says a 1986 Chevy Celebrity has a curb weight of 2714 pounds. Different options would change that weight.
The taillights are supposed to go on when the headlights are activated.
To change the alternator in your 1986 Chevrolet Celebrity: 1, Remove the battery ground cable. 2. Unplug remove the wiring from the alternator. 3. Loosen the bolts that hold the alternator in place. Remove the drive belt. 4. Remove the bolts and the alternator will pull out. Reverse the process to reinstall the new alternator.
check to see if you have a speed sencer if not change your cable