Want this question answered?
check the chip in the ign key. Try another key if available
PASS-Key II uses a resistor pellet in the ignition key that is read by the system in your vehicle. If the key resistor matches the code stored in the vehicle system, the vehicle's fuel and starting systems will be enabled. If an incorrect key is used, the vehicle's fuel and starting systems are disabled for three minutes. Additional attempts during this lockout period will not start the car, even with the correct key. If the engine does not start and the STARTING DISABLED REMOVE KEY message is displayed in the Driver Information Center, your key should be checked for damage. Starting may be attempted with an undamaged key immediately. See your dealer or a locksmith for key service. If the STARTING DISABLE REMOVE KEY and WAIT 3 MINUTES messages are displayed, the key should be cleaned. After three minutes, try again. A START CAR message will appear at this time. If the engine still does not start, wait three minutes and try a duplicate key. At this time, fuses should be checked (see "Fuses and Circuit Breakers" in the Index). If the engine does not start with the duplicate key, your vehicle needs service. See your dealer for service. If the THEFT SYSTEM PROBLEM, CAR MAY NOT START message is displayed during vehicle operation, a fault has been detected in the system. This means the PASS-Key II system is disabled and is not protecting the vehicle. The vehicle usually restarts. See your dealer for service. If an ignition key is lost or damaged, see your dealer or a locksmith to have a new key made.
does your ignition ley have the proper code chip on it ? If you have a 2nd key try that. If that fails most likely key cylinder , must be checked
It can not be disabled, it is reset with the remote or by unlocking the door with the key.It can not be disabled, it is reset with the remote or by unlocking the door with the key.
your car key has a chip in it and in the ignition switch there is two connectors that run to a theft safety component. if your key as bent or there is a short it will not complete the circuit and it dose not allow the car to stat.
The alarm is disabled by putting the door key into the driver's door and turning the key.
It could be disabled by some program which made changes in your registry. What you need to do it is run a complete anti virus scan and if your computer is virus free do a system restore to the data your control key was working
1996 rodeo- how to remove key from lock ignition?
It can not be deactivated or disabled.
Push the key into the ignition. To remove, push in, then turn towards you to remove the key. I do not know how to remove and replace the whole ignition assembly in case that was your real question.
GM uses a Pass-Key 2 anti-theft system during the 1990's which go out quite often. To disable the system turn the ignition key to the on position without starting the car. Wait 30 minutes and turn it off. Repeat these steps 2 more times. After doing this 3 times the system will be disabled and you can start your car.-or-Remove The Anti-Theft Fuse
Remove the inside door panel. Remove the linkage from the key tumbler. Remove the key tumbler retaining nut. Reverse the process to install the new key tumbler.