Shut the water off. flush the tank and hold the lever down so as much water runs out as possible. Either use a sponge or towels to get the rest of the water out of the tank or have a pan or bucket ready to put under the hole in the tank to catch the water when you take out the old fill valve. Tale the supply line loose. Take the nut loose on the bottom of the tank that holds the fill valve in. Lift out the old valve. Install the new valve making sure you put the rubber washer on it first with the taper facing down into the hole. Secure the valve with the nut making sure it is sealed. Use pliers but don't break the nut. Reattach the supply line. There is a small hose that attaches to the top of the valve and runs to the overflow tube in the middle of the tank. Make sure this is in place. Turn the water on and set the water level. There should be instruction on the new valve.
how to replace a knock sensor on a 2000 Chevy 6.0 step by step
Buy a yamaha blaster manual. Shows you step by step picture by picture.
how do you replace an air condition condenser step by step on a 1996 Chevrolet silverado 1 ton dually?
visit www.newtiburon.com for step by step
Step 1: Grab a screwdriver and a manual Step 2: Remove the bumper light according to manual Step 3: Replace the light
Step by step instructions for Alternator replacement can be found at; http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528006183d
Try this website: diynet.com
free diagram step by step at www.jeep4x4center.com
Want to replace an existing subsided external concrete step.
a Haynes manual would be your best reference for step-by-step removal and installation of any do-it-yourself work
buy a manual
Yes here is the URL to a great step by step instructional guide.