0
Enough to show "Minimum" on the dip stick.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What is the difference between min and max on the oil dip stick?
The difference between min and max is, the min means the minimum amount of oil you can have in your engine, max means the max amount of oil you can have without causing overflow of the oil. You want it in between so when your engine gets hot and your oil expands a little bit it won't over flow your oil filter or dipstick, plus too much over the max level and you could cause oil filter problems, which then in turn can ruin your engine.
What is the full meaning of engine RPM?
revoltion per min in engine
What is the suggested warm up time for a 1989 ford bronco?
3-5 min drive safe
Is it a min amount of dollars that someone can take you to court?
no
What is the labor time esimate to replace the engine oil pan on a 96 mystique 2.0 ztec engine?
all that is needed to replace an oil pan is to remove the bolts holding it on (5-10 min) scrape the old gasket from engine block (10-15 min) and but new pan and gasket back on (5-10 min)
How many penalty minutes did Bobby Orr have?
The total amount of pims in his all time professional career is 145 min. OHA totals-45 min. NHL totals-92 min. And during the Canada Cup he got 8 min.
Is the 3.3 liter engine in a 2001 Nissan Xterra an interference motor?
hard strt and 10 min running engine and die
What is proper amount of exercise for 64 year old male?
15 min rowing
What is a healthy amount of time to work out per day?
its about 5-20 min the most.
How do you reset the engine immobilizer in a 2001 Chevy Malibu?
Leave the key on for about 15 min.
When idle no ignition should there be engine coolant in the container?
It should be all the time in the container. It has special marks MIN and MAX, the coolant level should not be lower than the MIN mark and not higher than MAX. You have to add coollant when the engine is cold.
How many miles to reset check engine light?
Check engine light off, codes cleared; cold start. -warm up engine 5 minutes (or until closed loop is reached--5 min is usually plenty) -drive (w/ steady throttle) at a steady speed between 40 and 60 mph for 8 min -stop and idle 3 min -drive (w/ steady throttle) at a speed above 20 mph for 2 min -turn key off, leave off 10 min
