Check engine light off, codes cleared; cold start.
-warm up engine 5 minutes (or until closed loop is reached--5 min is usually plenty)
-drive (w/ steady throttle) at a steady speed between 40 and 60 mph for 8 min
-stop and idle 3 min
-drive (w/ steady throttle) at a speed above 20 mph for 2 min
-turn key off, leave off 10 min
It is driving cycles not miles. It varies from manufacture to manufacture.
Have vehicle scanned to determine the problem
You do not have to reset the computer after this repair. If the Check Engine Light is on it is not because you made this repair. If you disconnected the battery the computer will reset itself.
Have vehicle scanned to determine the problem
unplug the negative side of the battery leave it off for 30 seconds.Also depends what you are trying to reset, check engine light ?
what do you reset the cehck engine light patriot manual transmission 2008? thanks for you support.
100 to 150 miles
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
The check engine light has to be reset with a OBD scan tool
You reset the check engine light with a scan tool after repairing the failure.
hoe do you reset the check engine light in a 1995 land rover
how do i reset the check engine light on a 1999 acura 3.2tl
Takes about 50 miles highway and city combined.
50 to 100 miles
The check engine light comes on in a car when there is a problem with the engine. It will go off or be reset when the problem is fixed.
You need a scan tool to properly reset the check engine light.
How do you reset check engine light for the 2009 Chevy trail blazer?
There is no reset button for the check engine light. It must be reset with an OBD scan tool.