Just might be a warning, have the car checked by a qualified brake mechanic/center. Please.
it could be the rotors
Replace freeze plug in a 1998 ford windstar ?
Not likely - the 1999 Windstar was a rather significant updating of design compared to 1995-1998 models.
A 1998 Ford Windstar would use refrigerant 134a
On a 1998 Windstar the vacuum reservoir tank is under the hood in the back left of the engine compartment when standing in front of the vehicle. Mine has a red and black vacuum hose coming out of it.
After changing the speed sensors on a 1998 Ford Windstar GL 3.8L, you typically need to reset the vehicle's computer system to clear any trouble codes and ensure proper operation. This can often be done by disconnecting the negative battery terminal for about 15 minutes, then reconnecting it. Alternatively, using an OBD-II scanner to clear any codes can also achieve a reset. Always check for any additional issues if the problem persists after the reset.
On a 1998 Ford Windstar : The 3.8 liter V6 engine ( and the 3.0 ) has a timing CHAIN
Not very likely - the Windstar was significantly redesigned in 1999, and the dimensions of the vehicle were changed.
To clean the Mass Air Flow Sensor (MAFS) on a 1998 Ford Windstar, first, ensure the engine is off and disconnect the negative battery terminal. Remove the MAFS by unscrewing the screws and disconnecting the electrical connector. Use a specialized MAF sensor cleaner spray and apply it to the sensor element without touching it. Allow it to dry completely before reinstalling the sensor and reconnecting the battery.
Mostly in the Windstar category - they all apply to the GL model
On the evaporator case.
On a 1998 Ford Windstar : ( # 16 / 20 amp )