cathode
First connect the positive terminal of the voltage line to positive terminal of multimeter and negative to negative terminal of multimeter. Select voltage in multimeter and measure the voltage
A DC voltage must have a polarity, however this polarity is always in reference to some common point and has no meaning on its own, the same with voltage. Usually this common point is the circuit ground, which may or may not be earth ground. Example: A household AA battery has a positive and a negative terminal, the positive terminal is +1.5v in relation to the negative terminal, and the negative terminal is -1.5v to the positive terminal.
If electrons are left behind in metal this will increase the voltage difference between a metal electrode and a solution. Also if the solution becomes more positive this will cause an increase.
im not sure how clearly your phrasing your question, but when dealing with circuits potential difference (voltage) is max, and at the positive terminal its zero. it decreases as you go around the circuit. hope this helps
Parts of a digital multimeter include an LCD display and range knob. There are also common ground, positive voltage terminal, and positive current terminal.
the negative terminal of the voltage source is attached to cathrode.
Electrode potential is the voltage that an electrode is at. This has to be measured versus a reference electrode
Note: When interconnecting A200 batteries (cells), they must be identical in voltage and amp rating! Batteries may be connected in series. The positive terminal of the first battery is connected to the negative terminal of the second battery; the positive terminal of the second is connected to the negative of the third, and so on. The voltage of the assembled battery is the sum of the individual batteries. The batteries are connected: + to - to + to - to + to -, etc. The capacity of the battery is unchanged. Batteries may also be connected in parallel. The positive terminal of the first battery is connected to the positive terminal of the second battery, the positive terminal of the second is connected to the positive of the third; the negative terminal of the first battery is connected to the negative terminal of the second battery, the negative terminal of the second is connected to the negative of the third and so on. The batteries are connected: + to + to + and - to - to -. In this configuration, the capacity is the sum of the individual batteries and voltage is unchanged.
Monopolar electrode is single electrode measure voltage with respect to grond ,but bipolar electrode is two electrode measures the diff. voltage mainly bipolar is used inorder to get high Signal to Noise ratio.
Terminal voltage is the voltage gotten at the terminals of the load in any system.
It is recommended to remove the negative first. It causes less of a voltage spike if the ground is removed first.
The DC electrical system of the car requires a positive and negative electrical conductors for each electrical device. Taking the example of a single lightbulb powered by the car battery, this could require a wire leading from the positive terminal of the battery to one terminal on the lightbulb and a second (return) wire leading from the other terminal on the lightbulb back to the negative terminal on the battery. Two wires are required - a positive and negative. To reduce the quantity of wires required, the negative "wire" is actually the car body. Hence there is a positive wire leading from the positive terminal of the battery to the positive terminal of each electrical device on the car and the negative terminal of each electrical device on the car is connected to the car body (a metal conductor). The body of the car is then connected to the negative terminal of the battery, completing the circuit. There are virtually no return wires. This works as cars use a low voltage (12 V). If they used a higher voltage, this system could result in electric shock from touching the car body.