answersLogoWhite

0


Best Answer

2

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: The number of LED display indicators in logic probe are?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Natural Sciences

What are the components of an oximeter?

a light-emitting diode (LED), a photodetector probe containing a permanent or disposable sensor, alarms for pulse rate and oxygen levels, a display screen, and cables


Is the voyager 2 a space probe?

yes voyager 2 is a space probe


What is the name of the space probe on Saturn?

Titan, by the Huygens Probe, which was part of the Cassini-Huygens Probe.


How do you use an alternating current amp probe?

An amp probe is a hand held amp meter. It uses the magnetic flux that surrounds a wire when there is a current flowing it. There are different styles of amp probes, one the jaws clamp over the wire to form a circle around the wire and another type just pushes the wire into a U shaped jaw. These jaws then act like a current transformer (CT). Inside these jaws there is a coil of wire much like the secondary of a transformer. As the magnetic flux of the wire, under test, cuts the coils in the meter, a small current is induced into the meters sampling circuit. The output of the sampling circuit reads out on a moving needle or a digital display located on the body of the amp probe. At the factory where the meter is manufactured, the meter is calibrated so that the reading of the wire's magnetic flux is linear from zero up to the maximum rating of the meter. This is to guarantee that the actual current flow through the wire is what the amp probe displays.


What was sent to look at the planet mercury?

The Mariner10 space probe and the Mercury Messenger space probe.

Related questions

What is use of logic probe in electronic?

we use logic probe in circuit because logic probe is use to indicate where signal is high or low on ic chip.


Difference between logic probe and logic pulser?

1v1 me i will wreck u m8


What is the function of a logic probe?

To tell you the state of a logic signal, when the state changes are infrequent and the cost of an oscilloscope or logic analyzer would be inappropriate/excessive.


Which one of the following is useful in debugging a program that communicates via a network?

Logic probe(not sure)


What do time-temperature indicators do?

show if food has been time-temperature abused during shipment


How do you know if the component in your car is connected to ground correcly?

If you have a Power Probe, that can used to test grounds, as can the "logic tester" type of test light.


Will a 1994 Ford Probe Alternator fit on a 1993 Ford Probe gt?

if the 94 probe is a GT, yes. the 2.0l alternators are different from the GT the autozone part numbers for the 94 2.0L Probe is 14449 and the part number for the 94 2.5L GT is 14450


Parts of a digital multimeter?

1 x Digital multimeter with LCD Display (the body or main unit) 2 x test leads with attached probes (sometimes removable) - 1 x black negative probe - 1 x red positive probe


What is the probe size?

Probe,probe se 2.0 / probe gt 2.5


When do you receive your alien number?

after the probe, right before they return you naked to the drop circle.


What are the components of an oximeter?

a light-emitting diode (LED), a photodetector probe containing a permanent or disposable sensor, alarms for pulse rate and oxygen levels, a display screen, and cables


When did Patricia E Bath get her first patent for the Laserphaco Probe?

The first of Patricia Bath's four patents related to the Laserphaco Probe was Number 4744360, issued May 17, 1988.