window motor needs replaced , it is behind the door panel
You could also check your fuses because i just had a similar problem. i couldn't roll my power windows down and it was a blown fuse.
The directions are in your manual. Roll the window down, roll the window up, release the button then hold it up for two seconds, roll the window down, release the button then hold it down for two seconds. Repeat that for each window.
A power window relay switch relays the power from the car's battery, to the switch itself, and then to the window motor. When pressing the button inside of the car it allows the power to go from the relay switch to the motor and roll the window up or down.
have you checked to be sure that the driver lock out button has not been pushed. it is usually above the window controls and it use to keep small children from rolling down the windows.
You can manually roll up a power window by pulling on it. You can also remove the door panel and pull the window up.
The window is jamed, or your wires connecting your button to the window or busted.
You can but if the power window motor is bad it still won't roll up.
GOto each window, roll it half way, Then close it and keep holding button for 3 sec
PRESS THE BUTTON DOWNHOW DID YOU GET A DRIVERS LICENSE
Yes
1999 Pontiac motana mini van driver window will roll down but will not roll up ??????
Check out the end of this video for details on where the motor rest is and how to perform the reset. http://infinitihelp.com/diy/gcoupe/projects/infiniti_g35_window_motor_replacement_procedure.htm Original Answer: The window motors 'window travel distance' can be reset by : (do not use auto-up or auto-down function) • open door so window does not touch anything but door • press and ***hold*** window button to roll window down and hold for at least 5 seconds beyond window full roll down • press and ***hold*** window button to roll window up and hold for at least 5 seconds beydon window roll roll up This will train your door motor on the limits of the window travel ====== It is the black button/nipple thing on the actual motor. It can be accesses by removing the door panel and then lifting the black sticker in the center of the door. best of luck
you need to replace the window master switch