Check out the end of this video for details on where the motor rest is and how to perform the reset.
http://infinitihelp.com/diy/gcoupe/projects/infiniti_g35_window_motor_replacement_procedure.htm
Original Answer:
The window motors 'window travel distance' can be reset by :
(do not use auto-up or auto-down function) • open door so window does not touch anything but door • press and ***hold*** window button to roll window down and hold for at least 5 seconds beyond window full roll down • press and ***hold*** window button to roll window up and hold for at least 5 seconds beydon window roll roll up
This will train your door motor on the limits of the window travel ======
It is the black button/nipple thing on the actual motor. It can be accesses by removing the door panel and then lifting the black sticker in the center of the door.
best of luck
Reset the left rear door power window by removing the power window motor and connect both the motor and the power window switch to the vehicle's wire harness. Turn the ignition switch on and it should be able to reset.
possible motor issues if you hit the button and you hear NO sound then start with the motor. if there is a click or grinding the window fell off the track have to reset it.
Press the button to close the window and hold it for 5 seconds.
To reset the window motors on a 2000 Lexus RX300, start by fully closing the window using the power switch. Once the window is closed, hold the switch in the "up" position for about five seconds. Next, fully open the window and then hold the switch in the "down" position for another five seconds. This process recalibrates the window motor and should restore normal operation.
Close the window press the button again as if to close and listen for a click window reset
If you lift and hold the window operation button for 10secs this will reset your window correctly.
Remove the window regulator and motor again Remove the motor from the regulator Attach the motor to the electrical connector With the key in the on position Press the auto down switch until the motor stops Make a mark on the gear(this will help you count the revolutions of the motor) On the window master switch push "manual up" and watch the gear and let it turn at least six revolutions but no more than ten Reassemble everything and it will work.
A Chrysler Sebring does not have a reset switch.
There is no resetting it. Either your circuit won't close (could be due to a broken switch, broken or shorted wiring, a bad relay, etc.) or the window motor is toast.
The sensors are wheel position specific. They should reset themselves. If they are not in correct position they will not reset.
Chrysler/Dodge/Jeep vehicles do not use inertia/reset switches.
Call Infinity service