Remove the window regulator and motor again
Remove the motor from the regulator
Attach the motor to the electrical connector
With the key in the on position
Press the auto down switch until the motor stops
Make a mark on the gear(this will help you count the revolutions of the motor)
On the window master switch push "manual up" and watch the gear and let it turn at least six revolutions but no more than ten
Reassemble everything and it will work.
what the prucedure timing belt reset
Is there a separate fuse for every electric window in the 1999 landcruiser and if there is where are they.
You would need to reset the on-board computer if it does not automatically reset when the malfunction itself is corrected.
try disconecting the battery or pulling the ECM fuse
A Land Cruiser Prado is a mid-size, four-wheel drive vehicle made by Toyota Motor Corporation. The difference between a Prado TX and Prado TZ lies in the engine and trim levels available.
To remove the rear hinged window from a 100 Series Land Cruiser, first ensure the window is fully closed. Then, carefully remove any trim or covers around the window to access the mounting bolts. Use a socket wrench to unscrew the bolts securing the window in place. Finally, gently lift the window out of its frame, being cautious not to damage any surrounding components.
Land cruiser
how do you replace a antenna motor for a 2000 Toyota landcruiser
No, the rear right window motor and the front left window motor on a 2004 Land Rover Discovery are not the same. Each window motor is specifically designed for its location, taking into account factors like size, power, and mounting configuration. While they may share some similarities, it’s important to use the correct part for each window to ensure proper operation.
Toyota Land Cruiser was created in 1954.
To operate the electric windows without the ignition on a 79 Series Land Cruiser V8, you can use the accessory position of the ignition switch. Turn the key to the first position, which activates the accessory power, allowing you to operate the windows. If this does not work, you may need to access the window motor directly or check for a specific fuse that allows window operation without the ignition. Always ensure the vehicle is in a safe position while performing this.
To reset the timing belt light on a Toyota Land Cruiser, first turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. Turn the ignition off, then start the engine to check if the light has been reset. If the light remains on, you may need to consult the owner's manual or a professional for further assistance.