Want this question answered?
On your keyless entry remote hold down the panic button and trunk button at the same time till the remote light flashes. Then the "beep beep" of the alarm will sound when locking and unlocking your car.
Get out unlock the door with the key. Then get back it and try it
The battery in the remote may be dead, or the remote or security system may have a fault of some sort.
Which warning light is it?
put it on a concrete block jump on it till the red light stops flashing.
I had a problem too when I removed the battery from my Mentor's remote . Do the following ,sit inside the car , remove the remote battery , wait for 1 minute , replace the remote battery when doing so you will see that the remote light is on ! If the light is not on try again ! Now press and hold the lock button on the remote until you hesar the doors lock . Your remote is now programed .
You've tripped the alarm system. You have to reset the alarm with the remote control fob and then everything will work fine.
What does it mean when your vsa light is on Acura txs
When the LED light on an aftermarket alarm stays on, it means that the alarm is active. The light generally shows that the alarm status is "ready."
I would suggest checking all of the switches on your doors, or the alignment of your doors. Also, make sure your trunk is closing properly. Check that switch too. Your dome light is staying on probably because one of the doors isn't closing properly, or the switch is bad in one of the doors/trunk lid. Good luck!
Im not sure if you're talking about remote starters or alarms, but the alarm light did pop on when I changed the battery in my 95 Jeep GC Laredo. All I had to do was lock and unlock the doors a few times to reset the system.
i have an acura 1997 rl and the tcs light on. what can i do?