answersLogoWhite

0


Best Answer

Are your test strips old. Get new ones for accuracy. High pH= with the circulation on - add more muriatic acid and test in 20 min. Need 7.6 stabilized readings. Stabilizer= add 5# per 10,000 gal. You need 50 to 80 ppm stabilizer/conditioner levels. Add more chlor with circ. on and test with in 20 min. If no reading you did not add enough chlor. -- add more. Keep this up until you get the readings you need. Then that will be approx how much chlor your pool will take almost each time it needs it. But you have to get the condit. to required levels. It may take 3 to 4 days to get there depending upon how warm the water is.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

11y ago

You need to lower the PH adding muriatic acid, this can be purchased where ever pool supplies are sold, is the most common method try this page for more detailed info and instructions.

ALWAYS BE CAREFUL when handling ACIDS or Strong BASES

It is common to have your chemicals out of wack after storms and the heat and sunlight will affect them mor in the summer months not to mention the more trhe pool is used the care will be needed

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: The swimming pools test strips say that the stabilizer is too low and the pH is a little high and the pool is green what needs to be done Have put a lot of chlor but chlor residual won't come up?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why won't the stabilizer level stay up?

For a few reasons: -You are so unstabalized that the stabalizers can not go down -You are not moving -They are somehow already down


Your pool is clear but will not register chlorine?

How old are the test solutions or test strips? Replace if left in the sun or more than a year old. Do you have a chlorine odor? If yes, shock. Has the filter been cleaned recently? If not, clean. Do you have a chlorine stabilizer or conditioner added to the pool? If not add until residual is about 50 to 70 ppm. Add more chlorine and test for correct pH and alkalinity. Adjust if needed. Increase time on pump for the summer. Ken


Do cartoon strips appear in the newspaper?

Yes , cartoon strips are to be found in the newspapers and they usually have a color Sunday comics edition .


Which country did fettuchini come from?

Do you mean Fettuccine (little strips of pasta) if so then Italy.


Another word for cut into long thin strips?

another word for cut a little?


How do you check the ppm of salt in a salt system pool?

You can buy salt test strips and electronic salt testers at any good pool supply store - Leslie's carries them.


Why do test strips show no chlorine reading even after stabilizer and chlorine were added if the pH and alkalinity are fine?

How much chlor added? Add at least a gallon of chlor. less if vinyl pool. Test in 20 min. and adjust as needed. Ph and alk = fine. Hmm, what are your readings? How old are test strips? Have they been left in the sun or outside? = no good then get new ones. k


I have removed the reflective strips from an ambulance but can't get the residual adhesive off. Is there a solution for this?

I find that WD-40 actually works pretty well. And there are commercial products that are specifically designed to be "sprayed on" and will dissolve adhesive. Be sure to use a good grease cutter (409, Simple Green, Big Orange, etc.) to remove any residual adhesive remover, whatever one you choose.


What should you do about swimming with your ileostomy?

I get waterproof strips to stick around the base plates. You can get these from coloplast. Also I wear a costume especially made for people with stomas, there is a little pocket on the inside of the costume for peace of mind. I find that a patterned costume hides the lumps and bumps created by having a bag so no one knows you have one.


How water is contaminated?

To tell how acidic it is you can use pH strips. --- Hopefully not. There's so much chlorine in our tap water that when you turn on the cold water it smells like a swimming pool.


How do you get the alkalinity right in a freshwater tank?

You can buy pH tester strips from any pet shop, use them to determine the current pH. level, which is how acidic or basic the water is, and then you can buy tablets to correct the pH and alkalinity to a neutral 7.0. The brand of dip test strips I use is Jungle Quick Dips and the stabilizer I use is Jungle Correct pH, they have worked thus far since I have became an aquarium hobbyist.


What is a normal colour of a cocoon?

brown with white strips brown with white strips brown with white strips brown with white strips