answersLogoWhite

0

1100 ohms, +/-5%

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is the color coding for resistors?

orange-orange-orange


How do you read resistor values?

Resistors have standard colors for identification of the resistance value. In order, the colors are: black, brown, red, orange, yellow, green, blue, violet, gray, and white. Reading resistors is a very simple procedure if you use the chart and formula below. Hold the resistor with the gold or silver band to the right and read the resistor from the left to the right. http://www.westfloridacomponents.com/reschart.html


How do manufacturers of resistors indicate the value of the resistance?

They use a color code. Colored bands on the resistor that tell the value. Some precision resistors have their value written on them.


What type of resistors can only have one ohmic value?

Fixed resistors have a single, predetermined ohmic value. These resistors come in various types such as carbon film, metal film, and wirewound, and their resistance value does not change once manufactured.


What is the value of a 4-band resistor with yellow violet orange and silver as the bands?

47000 ohms with a 10% tolerance Yellow = 4 Violet = 7 Orange = 1000 (this is the multiplier) Silver = 10% tolerance


How does the experimental value compare to the real value for your resistors?

EXACTLY


What is the value of a 1934 five dollar silver certificate with an orange seal?

A 1934 five dollar silver certificate in good condition is worth $33.00.


What is The Resister Colour Code?

0 - black 1 - brown 2 - red 3 - orange 4 - yellow 5 - green 6 - blue 7 - violet 8 - grey 9 - white 20% - no band 10% - silver 5% - gold Standard resistors use a system of 4 bands: 2 for numeric value, 1 for number of zeros following the value, and 1 for % tolerance. There are special codings using the above colors for precision resistors, temperature coefficients, etc. that are used where applicable.


Will the resistors ohmic value increase if you increase the voltage?

No.


What are the main condition for resistors in parallel?

Two resistors wired in parallel means that both resistors are soldered together to equal the value of a smaller resistor value. Both resistors will be connected to the same line on the circuit board and then both will terminate on the same final line they are assigned to. Thus, a pair of 100k ohm resistors can take the place of one 50k ohm.


Resistors which have only one ohmic value are called?

Fixed


What was the value of shipments in the electronic resistors industry in 2001?

The value of shipments in the electronic resistors industry in 2001 was $712.9 million, down from $981.7 million in 2000 and $970.6 million in 1999.