answersLogoWhite

0


Best Answer

That's correct it's electronic.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: There is no cable going to the cluster in a 1990 240 Volvo dl?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you repair instrument cluster electronics 1990 Volvo DL?

Repair is a big word.as there are several components to the cluster. What symptoms does it display?


How do i clear codes for 1990 Volvo?

Try disconnecting the + battery cable for 5 minutes.


How do you replace a speedometer cable on a 1990 acura integra?

Start by removing the gauge cluster, unhook the speedometer cable from back of cluster. Pull speedo cable thru the firewall, follow it down to the transmission, and then unhook it. Install in reverse order of removal.


Where is the power steering located on a 1990 Volvo 740?

Well the power steering cable is right next to the throttle cable on the throttle body.


1990 Volvo 740 turbo Accelerator pressure too hard?

Probably throttle body clogge or cable


How do you change the speedometer cable on a 1990 Nissan 240sx?

The 240sx does not use a speedometer cable. It is electronic. The VSS (vehicle speed sensor) is located on the transmission. It sends pulses.AnswerI removed my entire guage cluster and never saw a cable, it was all electronic. not sure if that's where the cable would be, but that's what i found, just three plugs coming out of the cluster.


How do you get to the speedometer cable of a 1990 Toyota 4x4 pickup truck?

There are two types of speed sensors and you can't tell until you look. One is electrical/magnetic (VSS) and one is a cable that goes directly into the instrument cluster. Here is my answer to How to replace the Speedometer Cable in a 1990 Toyota 4x4 Pickup 3.0 3VZE V6. To remove the cable you will need to unhook the e-brake assembly and seperate the speedometer cable from the e-brake at the firewall by the gas pedal. On end goes to rear of the instrument cluster and the other end attaches to a small gear at the rear of the transmission. The instrument cluster will need to be removed.


Where is the speedometer cable located on a 1990 Subaru legacy?

it Goes from the Gauge Cluster. throught the firewall and connects down in the top passanger side of the tranny


Is my alternator for a 1990 Volvo if when you take the positive cable loose and it cuts off or could it be the battery?

all alternators require battery power to operate.


How do i fix my 1990 ford mustang speedometer cable from making noise?

I used WD-40 after pulling the cable out of the car. You can try just pulling the cable off of the transmission, pulling the gear off, then squirting the oil of your choice in the end. It is probably best to remove the cable from the gauge cluster inside the car. That is a lot of work so you may want to try from the trans first then if that doesn't fix it work from the gauge cluster end. It worked for me 6 years ago on my 1990 mustang lx 50 and no problems since.


When was Journal of Cluster Science created?

Journal of Cluster Science was created in 1990.


Need to replace speedometer cable on 1990 Dynasty Have cable repair kit can't find end of cable behind instrument cluster where does the cable come out from behind dash?

Are you sure you have a cable in your car You may have a speed sensor therefor it's electric speed control look on top of the tranny towards the back right above the axle for your sensor