0
This radio has 2 preamp outputs front and the other is selectable as rear or subwoofer output. ?
Wiki User
∙ 9y ago
This radio has 2 preamp outputs front and the other is selectable as rear or subwoofer output.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Do I need a preamp for good subwoofer sound and clarity?
No, a preamp is not always necessary for subwoofer sound. You will, however, always need some form of "crossover" to ensure that you only send bass frequencies to your subwoofer.
How do you test the output of an acoustic guitar preamp?
To test the output of an acoustic guitar preamp you may use output tubes to test. This will test the preamp voltage.
Can you install a subwoofer to my factory radio in your 2007 Ford Fusion?
Non-navigation radios can utilize the PAC AOEM-FRD24 module. I have it in mine, gives proper 4-channel preamp output.
Can guitar preamp be used for headphones?
It is not ideal to plug headphones into the "to amp" output but it will work and nothing bad will happen. Many preamps are available with dedicated headphone outputs along with an appropriate volume control.
Do you have to connect the RCA preamp output to a car radio?
These jacks are used to connect the head unit to a separate, more powerful amplifier. If you are powering your speakers directly with your head unit then these jacks are not headed. They can also connect to a subwoofer amp if a crossover is used to block the higher frequencies.
How do you install an after market amp in a envoy?
Im wondering if there is factory preamp outputs on an 08 GMC Envoy Denali with bose sound system.
How do you record voice from ahuja SSA-250m amp?
Connect your recording device to the preamp output on the back.
Can you hook up an amplifier for a car to a AV receiver for a home theatre system?
It depends on the specific models of each, but typically, Yes. Of course you will need a 12VDC power supply for the amplifier, though. You will also need a AV receiver with a preamp output. You cannot run speaker level outputs into the input of an amplifier.
What should one look for when buying a guitar preamp?
A guitar preamp helps in amplifying the original sound produced from a guitar. One should look for sound quality, output voltage, as well as input sensitivity. All these can affect how the sound will be amplified.
How do you balance surround sound speakers?
Usually you wouldn't need to but if you wanted to offset it from balanced or if your connection has a stronger signal in one channel than the other you can connect a preamp or an amplifier with balance control and audio inputs as well as out puts to the system. You would connect the wires going in to the surround system into the input of the preamp and then connect the output of the preamp into the input of the surround system. CAUTION do not turn the preamp volume up to high or you risk blowing the surround system.
What do guitar preamps do?
A guitar preamp is basically a guitar amplifier, but without the power amplifier section that drives the speaker. A typical guitar amplifier consists of two components: the preamp and the power amp. The preamp is responsible for generating most of the characteristics of the guitar tone. The power amp receives the output signal from the preamp, then raises it's level enough to drive a speaker so the guitar becomes audible. Physically, a guitar preamp can be an independent rack-mountable unit, a digital device (such as a Line6 POD), a floor pedal, or even circuitry inside the guitar itself.
What cables do you need to connect a microphone pre-amp to your computer?
A microphone preamp's output may be XLR or 1/4". You will need a cable that will adapt that output to a 1/8" stereo plug for the line input of your computer.
