0
What else can I help you with?
Where is a startup password or power on password stored?
These settings are stored in the computer's BIOS. Sometimes it is also referred to as CMOS.
When does a computer access ROM?
A computer accesses ROM (Read-Only Memory) when it needs to retrieve essential instructions and data during the startup process or when performing basic functions.
What are xp boot files?
Files the Computer runs during startup. Gennerally before you even enter desktop.
Which memory is used during startup computer?
RAM (random access memory) in order for the operating system to run, RAM must be inside the computer.
The area that holds all the startup instructions the computer needs to start is the?
The area that holds all the startup instructions a computer needs to start is the BIOS (Basic Input/Output System) or UEFI (Unified Extensible Firmware Interface) firmware. This firmware is stored in a non-volatile memory chip on the motherboard and is responsible for initializing hardware components and loading the operating system during the boot process.
Which registry key contains plug and play information about the hardware configuration that is used by the computer at startup?
The registry key that contains Plug and Play information about the hardware configuration used by the computer at startup is located at HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Enum. This key stores details about all detected hardware devices, including their configuration and status. It is essential for the operating system to manage hardware resources effectively during the boot process.
When is the hardware test in a PC first performed?
During the initial startup phase, right after your computer performs POST (power on self test)
What is the blue light during mobile startup?
It just means that the phone is still loading, so be patient. Much like turning on a computer.
Where can you configure which device you want to load during the OS start up?
In XP...Start,run, type in MSCONFIG...hit ok...look for the startup tab and uncheck anything you don't want at startup - Click apply then ok. Then Restart ...when the computer starts back up you will see a box stating that you are running windows in selective startup. check the box that says "do not show this notice again" then hit ok. that's it ! If you are uncertain which devices to disable at startup, you can either leave them checked or do an internet search on the item and the intenet will have information on what the process is.
Why won't my computer let me log in?
You might have forgot your password when you changed it last time. Or During the last shutdown the password must not have saved properly and either the password containing file might be damages or you must try your last password. If not then reset the system.
Which are the files that the computer runs during the startup?
Depending on the computer type the start up files can differ, but generally the computer runs the bios files first, after that it will load the core components of the operating system and then run further no core parts as needed
What is the pre-boot sequence?
Preboot Sequence During startup, a Windows Server 2003-based computer initializes the boot portion of the hard disk and the preboot sequence begins. This sequence consists of four steps: • The computer runs power-on self test (POST) process to determine the amount of physical memory; and • The hardware components are present. • If the computer has a Plug and Play (BIOS), enumeration and configuration of hardware devices occurs. • The computer BIOS locates the boot device and loads and runs the master boot record (MBR). Note: Windows Server 2003 modifies the boot sector during installation so that Ntldr loads during system startup. Therefore you should disable the Boot Sector Virus Protection in your BIOS Setup.
