Chevy Corsica

Torking pattern for head on 93 Chevy Corsica?

232425

Top Answer
User Avatar
Wiki User
2005-11-03 06:20:37
2005-11-03 06:20:37

2.0 or 2.2 engine long bolts 8 4 1 5 9 7 3 2 6 10 short bolts exhaust manifold side here 2.3 engine 10 4 2 6 8 9 5 1 3 7 v-6 engine 6 2 3 7 5 1 4 8 hope this helps wolverine

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

A used head gasket is not worth anything, because it cannot be reused.

User Avatar

46 foot pounds on short bolts 54 foot pounds on long bolts + 90 degees

User Avatar

Possible problems: 1. Clogged Fuel Filter 2. Water in Fuel A. Bad Fuel Supply B. Blown Head Gasket

User Avatar

a Chevy 202 head, is a fuely head with a 202 intake valve

User Avatar

the head could be warped BUT try removing the thermostat because that could be a bad thermostat try running it without it if its a blown head will not have compression and the oil will look milky

User Avatar

yes i do what picture do you need?? i need the head bolt pattern for a 2.2 liter engine

User Avatar

1987 Chevy head bolt torque 2.5L?

User Avatar

what is the torque setting for the head bolts on a 2007 chevy malibu with a 2.2L engine

User Avatar

no the inside of the head will be a different size

User Avatar

what is the preceger for replacing the head gaskets on a 1993 chevy suburban 4x4 350

User Avatar

Remove the cylinder heads from your Chevy engine. Remove the head gasket and clean the head gasket surface. Put the new head gasket on and reverse the process.

User Avatar

Hey Richard==It is quite involved but if you want to try it get a manual on your car. It will have pictures and everything. GoodluckJoe Replacing the head gasket on any vehicle is a long and complicated process, however if you wish to see basic step-by-step instructions go to the related question on the right side of the page "How do you replace a head gasket?"

User Avatar

Remove the cylinder head from your 1992 Chevy Lumina engine. Remove the head gasket and clean the surface. Put the new head gasket on and reverse the process.

User Avatar

2004 chevy aveo 1.6 head bolt torque specs

User Avatar

That would depend on which engine and what type of lube/sealant is used on the head bolts. Can't answer the question without more information.

User Avatar

You will need to remove the cylinder head from your 1994 Chevy. Remove the head gasket and clean the surface. Put the new head gasket on and put the cylinder head back to its original position.

User Avatar

You will need to remove the cylinder head from your Chevy Lumina engine. Remove the head gasket and clean the surface. Put the new head gasket on and return the cylinder had to its original position.

User Avatar

start in the center then go to the bolt to the right top then bottom left then top left then bottom right and keep working ing that pattern until you get them all

User Avatar

I need head bolt torque specs and sequence on 2003 Chevy Malibu 3.1

User Avatar

write down the casting number under the valve cover and compare it to the list of chevy head castings at mortec.com


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.