I just did an intake manifold job on a 1999 5.7L suburban. The intake manifold to the heads, note this sequence....from front to back on the passenger side 7,1,3,5......from front to back on the drivers side 8,4,2,6. Tighten # Tighten the bolts on the first pass in sequence (1-8) to 3 N·m (27 lb in). # Tighten the bolts on the second pass in sequence (1-8) to 12 N·m (106 lb in). # Tighten the bolts on the final pass in sequence (1-8) to 15 N·m (11 lb ft). Use Loc-tite blue on these bolts and follow the above sequence and torque levels.
1996 chevy c1500 pick up 305 motor bolt torque spec intake manifold
the torque specs for the intake manifold are 115 inch pounds inch pounds to newton meter = mutiply .113 by the number of inch pounds aprox. 9.5 foot pounds
Remove the intake manifold retaining bolts from your 1996 Chevy Astro Van. Remove the manifold gasket and clean the surface. Reverse the process to install the new intake manifold gasket.
Haynes manual says 115 inch pounds- Start from center of intake using a criss-cross pattern, working your way to ends of intake.
i checked with my brother who is a a.s.e. certified mechanic. it is 11 ft-lbs be sure to chase the threads with a tap and die set, and use locktite. to much torque will ruin the gasket, and not enough will cause a manifold leak.
by hand :)
where is intake manifold runners control stuck 1997 lincoln continental
Atlanta GA...I just received an estimate of 4 labor hours to remove the intake manifold of a 1996 E300D
21ft lbs
For the 1996 Saturn SL1 1.9 liter 4-cylinder, the torque in sequence one is 22 ft/lbs. In step two, torque in sequence to 37 ft/lbs. In step three, turn all the bolts 90 degrees and double check the final torque in the sequence.
your torque spec will be 65ft.lbs. Make sure you have the torque sequence too.
coolant by pass hose needs repaced under intake manifold to water 1996 Lincoln town car