0
You need to use the Chiltons Book for Corvette 1963 to 1983. It has the most complete information for your tune up needs. The book also contains information on the interpreting serial numbers. A great how to guide for the corvette lover.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you tune my 1968 chev corvette 327 engine?
Are you looking for the specs. or more. Let me know on my board I will try to help.
What are the timing specs on a 1968 Corvette?
Factory stock ignition timing for the Corvette 327 ci 350 HP is 4 degrees BTDC.
What is the timing on a 1967 Corvette 327?
There were a few different 327's offered that year, but, if you go 4 degrees advanced, or BTDC, it will run fine.
What are the specs on a gm 327 casting number 3903352?
its a 1967 engine most likely from a chevelle with 275 HP
What are the engine torque specs for 1995 Chevrolet Z28 327 engine?
First of all the 1995 Z28 had a 350 (LT1) not a 327(the 327 stamp on your engine block has nothing to do with the size). The specs for the '95 Z28 350 are: 275hp and 325 lb-ft
Degree timing 327 1968 Corvette with 300 HP?
The degree timing for a 327 cubic inch engine for a Chevrolet Corvette with is 4 degrees before top dead center. This engine is rated at 300 horsepower.
What is the point gap for a 1967 327 engine?
non existent.327 is a Chevrolet engineBut in a 1967 327 on a Chevrolet the Point gap is 19 thousands. Dwell angle is 28 to 32. Idle 700 RPM's
1965 327 Small Block out of a corvette you would like information on how to get correct engine timing for this motor?
327/275 and 300hp, 8 degrees btdc.
Where is the water temp sending unit on a 68 Corvette with a 327 cu in motor?
its next to the thermostat housing
Where is the oil filter on a corvette Chevy 327 engine?
It is on the left / drivers side bottom rear corner of the engine.
What is the 1963 Corvette top speed?
The 1963 Corvette has a top speed of 229 miles per hour. This model car has a 360-hp fuel-injected 327 V engine.
What are the torque specs for 327 rocker studs?
50 lb/ft lubricated with oil. Check out the link I posted.
