Figure out your engine type, then ask how to set timing on a 1988 corvette ***** engine. That should help you a great deal.
The degree timing for a 327 cubic inch engine for a Chevrolet Corvette with is 4 degrees before top dead center. This engine is rated at 300 horsepower.
The correct timing for a Mercruiser 3.0L 140 engine is 6 degrees BTDC. for a Mercruiser 120 the correct timing is 8 degree BTDC.
there is no timing belt it has a timing chain
correct yes there is engine timing on a mark 2 golf, as with all cars funnily enough.
The timing for this engine is electronically controlled and not adjustable
after replacing points in engine, can correct timing be done to engine if engine is not run.
The same way you set the timing of any Z24 engine. The vehicle it is in makes no difference. Do you know how to use a timing gun.
Factory stock ignition timing for the Corvette 327 ci 350 HP is 4 degrees BTDC.
6 degrees btdc
The 1977 Corvette 350 LS has ignition timing standard in this model. The purpose of the ignition timing is to help start the car in synchrony.
You can not set the timing with a timing light on that year engine. The timing is controlled by the PCM./ Power train control module. You must have an oBD2 engine scanner to set the timing. If the timing is off then the check engine light will be on.If you have not removed the distributor are moved it around for any reason then the engine timing is correct already. No need to adjust it. Computer does it.
This is a non-interference engine, meaning if the timing belt breaks it will not damage the engine.
Different engines need different timings, look at the handbook.
A 1976 Chevy did not have a points ignition, but that has nothing to do with the correct timing. You will find that the engine runs best with about 8-12 degrees BTDC.
How in the heck did you get a v6 engine in a sephia first of all!?!?!?!?
YES!!! The pistons WILL contact the valves and destroy the engine if the timing is not correct.
There is no way to tell you, because the timing is controled by the computor. You can not use a timing light. It requires an OBD2 engine scanner to set the timing to specs.
what motor do you have in it
Check water pump and pump gasket.
every system has its own marks and settings. You need to provide make model year engine to get a correct answer
The mark is on the harmonic balancer. The pointer should be visible by looking down from the passenger side of the engine compartment. They're usually bolted to the timing cover.
it should be 4 degrees before btc
The 2.7L didn't come out until 1998. So reask question with correct year, make, and model information.