The simple answer is yes. there are two engines in talons, lasers and eclipses. or better known as dsm's. (diamond star motors). there is the 4g63, and the 420a. which both come in turbo and non-turbo models. if you are looking to swap a turbo 4g63 into a non turbo 4g63 shell, the swap is simple. same as if your swapping a turbo 420a into a non turbo 420a shell. now, if your looking to swap a turbo 4g63into a nonturbo 420a or vise versa, you will encounter problems with motor mounts, wiring etc. keep in mind the wiring and ecu's etc will be different on each motor.
yes
Yes; an eclipse and talon are built identical except for exterior trim parts.1995 was the first year for the second generation eclipse/talon. the talon model was discontinued in 1998.
yes
Possibly under the Engine itself in the back next to the firewall. You may have to take out the Battery and Battery Tray.
fter alot of fabrication yes it will but it wouldn't make any sense itd be cheaper to get an eclipse or a talon or a Mitsubishi l200 truck
Yes, the Chrysler 420a was produced in the early to mid 90's and put into a number of cars. Including the Mitsubishi eclipse and the eagle talon, it is the same engine and essentially the same car.
1990-1999 Talon/Eclipse=5x114.3 (4.5)
yes
Plymouth Laser 92-94 and Mitsubishi Eclipse 93-94 for the 2.0L engine.
VERY HARD AND VERY EXPENSIVE. I do not recommend. You would spend less money buying a talon or eclipse with the 4g63 engine!
yes it will fit
The ECU is a known culprit on these cars. Check the net for "Talon ECU problem." I had exactly the same problem (sometimes would run perfectly, sometimes engine would cut out and would turn over, but would not start) on a 1995 Talon nonturbo and got a replacement preprogrammed ECU off of ebay. Runs perfectly now. I had spark at the wires, fuel at the line, new dist. cap, plugs (properly gapped), rotor and wires, fully charged battery. Replaced the ECU and the car started.