answersLogoWhite

0


Best Answer

The answer is YES provided the following: The buck boost Xformer is rated to provide the amperage required by the bed. The amperage rating should be on the electrical nameplate on the bed or inhte instruction manual. That you wire the secondary of the Xformer to the exact correct leads for the beds required voltage. (220V, 230V, etc.) Most bb Xformers do not come with a cord and "plug" to go into a 110V oulet, so you must also correctly wire a grounded plug and 3 conductor wire to the correct 110V primary leads of the Xformer. Best to have a qualified electrician do this, not a "wanna be" or handyman type. If miswired, the Xformer will "smoke" as soon as you plug it in and may damage the tanning bed! (And bb Xformers aren't cheap.) I'm sure tanning beds aren't either. Also understand, that when you take 110V and "boost" it to 220V, you are reducing the amperage by 50%. Therefore, if you're plugging into a 15 amp residentail circuit, you're only providing 7.5 amps which may not be enough to operate the bed. Ulimately, you're far better off to install a designated 20 amp, 220V circuit from the main panel to supply power to your tanning bed.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Using a buck boost transformer can you plug a 220 volt tanning bed into a 110 volt outlet?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What does a buck boost transformer do?

A buck boost transformer is a type of transformer that is used to make adjustments to the voltage applied to alternating current equipment. These transformers are typically used in back up supplies or in tanning beds.


How do you design buck- boost transformer primary and secondary voltage?

how to designing 2000 watts buck boost transformer


Are tanning bed lotions only for tanning beds?

Nope! Tanning lotions work by being activated by UV light, so whether your indoor tanning or outdoor tanning, you can still use a tanning lotion. Using a lotion specifically for tanning will dramatically help boost your color to get darker faster, plus it has a lot of vitamins and minerals to help prevent fine lines and wrinkles.


What is meant by boost transformer?

U doht


When wiring a single phase buck and boost transformer what connection is used to get a ten percent boost on the line input?

A rather strange question, as most transformers are installed by trained individuals who wouldn't be using this forum for help. However, it will be necessary to refer to the manufacturer's specifications for that specific transformer in order to determine how to achieve the desired output.


Does a transformer boost electric energy?

The transformer doesn't "boost" energy. If the voltage on the output side is higher than the voltage on the input side, then the current is lower. The power (energy every second) on either side is the product of (voltage) times (current), and that product is the same on both sides of the transformer.


Can you boost your 240volts to 277volts?

The easiest way is with a transformer that gives the ratio of (277/240) times.


When the series boosting transformer needed?

A buck/boost transformer is used to lower (buck) or raise (boost) the utility supplied voltage to the non-standard voltage required by some equipment, can also be used to raise the voltage that has dropped from traveling too long of a distance.


Can you make a sentence using boost?

I have a boost of confidence in myself.


How does a buck-boost transformer work?

A Buck Boost transformer is an auto transformer with a small primary to secondary voltage difference. It effectively adds or subtracts a few windings to the secondary to increase or decrease voltage. Here is an example: Say I have a 110 v and want 120 v; I have an auto transformer with 120 windings, tapped at 110 and 120. If I connect the 110 connection to my incoming 110v line, the voltage at the 120 tap will be 120v.


What device raises voltage?

Depending on your application... Use a voltage dividor (two resistors) if it doesn't draw a lot of current. You could also try a voltage regulator or using an op amp as a buffer, with the input the voltage you want. That voltage could come from a voltage divider, since op amps draw extremely low current.


What sentences can you make using the word boost?

your mum gave me a boost last night.... :P