answersLogoWhite

0


Best Answer

is your brake pedal hard as a rock? make sure you check the power brake pump relay 80 % the relay is bad. its located on drivers left side under hood against fire wall around master cyl make sure you first pick the right rekay second bring it and but it from dealer only if you ask nicley he will print the exact relay to change this car is loaded with relays and are the cause for most of the problems that occur with this model ive had about no bs 7 of these care and never changed a pressure pum just rekays hope it works if it does you will here the pump whine when the key is turned on good luck g

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Vacuum brake converion on a 1988 Lincoln?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you find out the leakage on brake for xjs-12 jaguar 1988?

brake leakage? or vacuum assisted vacuum leak?


What is needed to convert a hydroboost brake system to a vacuum power boost system on a 1988 Lincoln Mark VII?

Remove the hydroboost unit from the firewall and replace it with the vacuum assisted booster. If you are careful you may be able to do this without disconnecting the brake lines. You will need new powersteering lines and find a vacuum source for the new booster.


How do you replace brake pads on 1988 lincoln mark vii?

Front or rear?


Where do you find the vacuum reservoir on a 1988 Lincoln Town Car?

Vacuum reservoirOn the left and right fender well, the one on left is cruise controll & the right is the atc


The brake are hard and the brake pump won't start on a 1988 Lincoln Mark VII?

if the check brake light is on, the accumulator is bad. this part will run 700.00for a rebuilt one. the other option is to replace the brake system with a non anti-lock brake system


Where is the brake fluid reservoir on a 1988 Lincoln town car?

under hood Drivers side on firewall Black cap on white reservoir


What are the release dates for Lincoln - 1988?

Lincoln - 1988 was released on: USA: 27 March 1988


Vacuum diagram for 1988 Chevy Nova?

how do you hook up vacuum lines in a 1988 Chevy nova


Why does the S-10 1988 V-6 stall every time I press the brake we can't drive it and it sounds a little rough it was parked for about a month?

if you have power brakes, then it may be a vacuum leak. probably near the master cylinder. there should be a hose from the motor to the master cylinder. its possible the hose is the problem, not the master cylinder. when the brake is pressed, the vacuum helps push the brakes. when the vacuum in the motor is down to near zero then the motor will stall. so check the brake stuff near the firewall.


When did Brian Brake die?

Brian Brake died in 1988.


Does your 1988 Lincoln town car have shocks or struts in the front?

A 1988 Lincoln Towncar has shocks in the front.


1988 bronco brake light switch adjustment?

The 1988 Ford brake light switch does not adjust, replace it with a new one.