duplicity
Without seeing it, it's only possible to make an estimate. Gutter folds are one of the more common printing errors; a clean, single-fold error might go in the $35 to $50 range. To get a more-specific value an error note should be evaluated in person.
It sounds like what you have is called a "gutter fold", an error that happens when one of the large sheets on which multiple bills are printed has a fold or crease in it so part of the paper does not get any ink. Gutter folds are among the most common printing errors; still, they might retail for upwards of $40 depending on the size of the fold.
The error you have is called a "gutter fold". While many printing errors can be worth hundreds, gutter folds are relatively common and worth $30 to $60 depending on the bill's condition. FWIW, most likely the paper was already folded before the bill was printed. Blocks of bills are printed on plate presses which means the chances of a fold happening at the time of printing are quite low.
A FOLD AGAINST THE DIRECTION OF THE WEB 11 X17 IN HALF TO 11 X 8.5, THEN TO #10 ON THE DELTA FOLDER
It sounds as if you're describing a "gutter fold" error. It's one of the more common printing errors and would probably retail in the $30 to $60 range depending on the bill's condition and the size of the crease. Gutter folds happen when a piece of paper doesn't go into the printing press evenly, similar to what can happen in a home or office copier.
7 times
What you have is an error called a "gutter fold". It happens when there's a fold in the sheet of paper as it enters the printing press. Without seeing it in person it's difficult to estimate a value, but many gutter folds retail in the range of $35 to $65.
One can find a template for a tri fold brochure in the following sites; Microsoft, Adobe site, Printing For Less, Stock Layouts, Open Office, and Computor Companion.
It would be hard to evaluate without seeing it. The value of a mis-perf depends on many factors, including how far off the perfs are and whether it is a single stamp or a group of stamps where the mis-perf is easier to understand. It is often caused by a sheet of stamps getting a fold in the printing process.
You can use normal size 8½ x 11 when printing in Landscape mode.
The value can vary widely, from just $100 to much more. Unfortunately, the term "mis-cut" isn't specific enough to estimate a value. Please check your bill again and post a new, separate question with more details; e.g. Does the bill show part of another one? Is there a fold in the printing? Is it cut at an angle?
The answer will depend on the currency and the person doing the folding - you will find it quite difficult to fold coinage!Currency notes are made with different qualities of paper - many have textile fibres in them and their resistance to tering will depend on the exact make-up of the paper. Furthermore, some countries (Australia, for example) have plastic notes which are far more resistant to tearing because of folding.