If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.
If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.
If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.
loosen the bolt in the center of the drive belt pulley, then loosen the bolt on the side of the pulley. as you loosen the side bolt the tension lets up
To remove the accessory drive belt or the serpentine belt from the motor on a 1989 Sunbird, it is necessary to loosen the belt tensioner. Look for a pulley that has a bolt in a slot. Loosen the bolt and move the tensioner so there is a gap in the belt. Then remove the belt from each pulley.
The easiest way to loosen the tensioner is to use an automatic belt tensioner. This can be used on a serpentine belt which is connected to every pulley on the engine.belt.
Set the parking brake and disconnect the spark plug wire. Remove the cutting deck and the battery. Loosen the pulley and remove the upper belt. Remove the belt guide and the belt keeper. Loosen the bolt on the crankshaft pulley. Remove the lower drive belt.
you can put a wrench or a socket on the tension pulley, releasing the pressure on the belt.
You can change the drive belt, on your lawnmower, by loosening the tensioner pulley. With the tensioner pulley, loosen the drive belt will come off and can be replaced.
There is no "fan belt"; the 2.5L V-6 has two accessory drive belts, both with tensioners (loosen the large nut in the center of the tensioner pulley, and adjust the threaded adjustment rod), and the 2.0L I-4 has a single accessory drive belt with a tensioner (loosen the clamp bolt & adjust the threaded adjustment rod).
fans are driven electronically no belt. The serpentine belt is taken off by taking the tension off at the tensioner and replacing by following the pattern on your strut tower.
Depending on which belt there will be an idler pulley mounted to a long adjusting bolt. Loosen the nut on the pulley and then loosen the adjusting bolt and remove belt. Reverse order of directions for installation. The alternator will have a similar design on the bottom of the case that allows for adjustment/ removal.
Loosen the pulley first and then the belt should loosen off the tracks., follow the diagram on the hood
Loosen the tensioner pulley. The tensioner pulley will slide to the right. This will loosen the alternator belt. So it can be removed.
Loosen the tensioner pulley. When the tensioner pulley is loose the belt will come off. Put the new belt on and tighten the tensioner pulley.