0
What else can I help you with?
How many nails did it take to build the rms titanic?
Nails were not used to build the ship. It was made of steel. Rivets are used in steel.
Where on the Titanic was the label to tell that it was the Titanic?
On the back of the ship it said Titanic Liverpool, because Liverpool was its port of registry.
Where was the Titanic furnished?
the titanic was furnished in Liverpool
What did the two plaques on the Titanic say?
titanic liverpool
What two words were on Titanic's stern?
"Titanic Liverpool"
Why did Titanic have Liverpool written on the back?
Liverpool was to be the registered home port of the Titanic. The home port is marked on the ship.
What was the purpose of a double hull vessel?
for hull saftey, because of the titanic
What was the biggest part on the titanic?
By far, the largest part of Titanic was her hull.
How thick was the steel used to build the titanic?
The upper decks which make up the superstructure of Titanic are made with 1/4" steel. The hull itself is an inch thick.
How long was the titanic hull steel plates?
The steel plates of Titanic's hull measured six feet high by thirty feet long.
What was the purpose of the Titanic's inner hull?
It meant to strengthen the ship. Titanic's steel hull, the main body of the ship, had been reinforced with a second hull fitted inside. That is why people used to say the Titanic was unsinkable, so this belief lulled everyone on board into a false sense of security, which was to have tragic consequences.
When the Titanic boarded?
Liverpool docks
