Buy a new CV Axle Halfshaft and a new axle nut comes with it.
Leave the vehicle on the ground until you have loosened them.
the size is 1"-1/4" ( one inch and a quarter)
No it is not reverse thread. The passenger side rear spindle is the reverse thread on 88-93 festivas.
located in the right wheel well behind the right side of the bumper. held on by one nut and bolt. in front of metal shield to protect from dirt. visible only after removing nut and bolt. trace location by single wire.
Yes the rear bearings are replaceable . Bearings and the races are very easy to replace or repack , It may have a castle nut with a cotter pin or a crush nut , if it has a crush nut you may want to order a new one before you take it apart .
Front: 233 Ft. Lbs. Rear: Final Torque, 173 Ft. Lbs.
34mm Metric.
22mm
beleave it or not its cheaper to buy the axel than jusy the cvjoint, its not that hards to replace an axel, you need to remove the tire on that side, you will see a big nut in the center of the wheel that is your axel nut take the nut loose then you will need a hammer drive the axel thru until it is free, then you will see your strut theres 2bolts running thru the strut remove the 2 bolts after removeing the bolts from the stut pull down on the spendel and release the axel after the axel is free from the spendel grab the axel and pull it out of the trasmision not sometimes it can be hard but it will come so don't be worred and to replace the axel do everthing in revers.note after replaceing the axel the car has to be lined up you can call the parts store and they can tell you how tight the axel nut has to be. i hope this will help you
34
36 mm
35mm