Want this question answered?
Yes if the compressor has oil in it, drain it out and measure what comes out. A good general rule is about 3-5 oz to put in the new compressor. Make sure to put it directly in the suction side(low side) of the compressor and turn it about 10 times .
PAG oil goes in the air conditioner compressor. It is added in the same place as the refrigerant. However, this oil must be added before the lines for adding the refrigerant are put in place.
5qts with new filter.
You should not put any oil in a Ford air conditioning compressor. The air conditioning compressor runs on Freon. The system should take about one pound of Freon.
Yes, Because it won't work right if you do not oil.
If you only replaced the compressor, 2 to 3 ounces.
Yes!
The oil is in the freon along w/leak detector.
3 or 4 ounces.
It is added through the low pressure line when refrigerant is added if it is a new compressor put it in the low pressure side and you may need to push down gently on a check valve inside if equipped. an average amount of oil is 4 ounces but you need to check the manual to be sure, in my case the install instructions referred me to the owners manual which was no help, as was the haynes. I called the parts store and they looked it up for me.
6-ounces once the compressor has been completely drained...........
if your uing air tools on the compressor then you will put one or two drops directly into the inlet where you connect the compressor hose