It is added through the low pressure line when refrigerant is added if it is a new compressor put it in the low pressure side and you may need to push down gently on a check valve inside if equipped. an average amount of oil is 4 ounces but you need to check the manual to be sure, in my case the install instructions referred me to the owners manual which was no help, as was the haynes. I called the parts store and they looked it up for me.
8oz.
Yes
This is just a guess so take it with a grain of salt. I would buy a belt for the s10 without air conditioning and just bypass the air conditioning pump.
block and heads are the same but not the computers
There is no "kill switch" on that Chevy Blazer.
In our 96 Blazer S10, it was behind the radio. We had to remove the radio to get to it.
the 1996 and 1997 are the same and would not work in your 2000 straight from GM
5 on 4.75
Where is evap canister located on a 1996 chevy s10 blazer? It should be found above the rear axle on the drivers side, mounted to the inside of the frame rail.
The firing order for a 1996 Chevrolet S10 Blazer is 1, 6, 5, 4, 3, 2. The number one cylinder is on the front right as you face the engine.
nothing
or you talking about the driveshaft u-joint?